I couldn't help but laugh when I read the report of Mr. Daniel Mikat of Toyota in the June meeting of IWC. However, I think that the chapter of China's electric vehicles entering wireless charging has to rely on ZTE's leadership, and can't laugh.
As shown in the figure below, the hardware part of the wireless charging is mainly on the car and under the car. The car is laid by the operator/service provider, and the car is laid by our car engineers.
In order to run this system safely and orderly, the basic coordination work needs to be coordinated between the wireless charging pile and the vehicle. According to Toyota, this piece needs to have a minimum interoperability requirement.
1) Communication (SAE J2847/6, ISO/IEC 15118-7)
SAE is generally a private standards body led by American and Japanese car manufacturers, and there is a dispute with the ISO/IEC European car factory. Fortunately, SAE is generally faster. There are many people voting in ISO/IEC. It is slower and has something to talk about.
2) EMC/EMI requirements (Incl. FCC Part 18)
In the FCC standard, the non-ISM band, 15&TImes; SQRT (power/500) is defined, and the initial test water of 3.3 KW is acceptable. The latter 6.6 or even larger is yet to be defined.
3) Radiation exposure (ICNRP2010) and medical device exposure limits
The wireless charging magnetic field will still come out. Here I still need to do more homework to see how the body responds after the big one. I am very curious to come to play a bus bus, when charging, is it necessary for everyone to get off or run a few tens of meters.
4) Improve the performance of charging
– single frequency (85kHz)
– define minimum efficiency
– Define the alignment accuracy (X, Y, Z), especially the Z direction directly determines the efficiency
– The depot defines the largest installation size
– Define the parking space installation location
– Anti-interference ability (TPMS, PEPS, FOB)
Walking in front is hard work, Toyota is quite powerful.
Summary :
1) GB has been established, how to play this stuff?
2) After conducting the standard of conduction, is it going to continue to close the door? I think if this wireless charging really does, the problem of security risks and utilization is not small.
3) Due to the communication industry, after our domestic propaganda, it is too myth to refer to the standard to the first-class enterprise. You can do it, but you can use it, at least send more engineers, and prepare some funds to do some Experiment, it is appropriate to speak according to the data
NTC temperature surface mount sensors are non intrusive type sensors consisting of a probe section designed for mounting to flat or curved surfaces.
Cables can be supplied with insulation or jacket in PVC, Teflon or Silicon. Some cables are also available with a stainless steel over-braid or stainless steel armor for additional protection.
With the properties of easy installation, surface temperature measurement, surface mount type NTC Temperature Sensor has been used to power supply, radiator, electric motor and generator. Temperature range is from -30°C to 105°C.
Surface Mounting Sensor
Surface Mounting Sensor,Surface Mount Sensor,Sensor Radiator,Surface Mount Ntc Sensor
Feyvan Electronics Technology Co., Ltd. , http://www.fv-cable-assembly.com