Before Li An Printing Technology Xiao Bian introduced to everyone the precision automation splitter has a large torque transmission, high precision indexing, smooth operation, transmission torque, high speed performance and other significant features, widely used in the field of automation, manufacturers should be how to proceed after purchase Assembly? The following is a look at the Li An Printing Technology Xiaobian.
The first is the whole, the installation of the body: before the divider is shipped out of the factory, it is a high-precision segmentation mechanism obtained by precision machining and correct assembly and adjustment. Before use, the user shall not arbitrarily adjust, disassemble, or assemble; correct the position of the input and output shafts, add the positioning pins, and evenly tighten the screws; the divider shall withstand the pulsating load moment and the installation must be very firm; confirm the installation of the divider Whether the surface is damaged or not, if it is damaged, trim it with oilstone.
Because the mounting surface of the precision automation splitter is relatively vertical or parallel to the input and output shafts, the mounting base of the equipment must ensure that the input and output shaft directions of the splitter are coaxial with the input and output directions required by the equipment. The divider cannot be skewed or eccentric. Therefore, when the divider is in an abnormally stressed state, deflection or eccentricity will not only affect the output accuracy, but also may severely damage the divider.
Then, in part, the installation of the input and output shafts: The connection related to the input and output shafts of the splitter should be rigid in the direction of rotation, and there should be no reverse impact and rotation-stable coupling.
At the same time when installing pulleys, turntables, flanges, sprockets, gears, etc., on the input and output shafts of precision automated splitters, attention should be paid to:
1. The input and output shafts are finished H6 grade, and the hole diameter is finished into H6 grade. It is ideal for press-in. In this case, the coordination of the upper and lower limit deviations of the holes and shafts must be avoided. The key connections must not be too loose.
2. It is absolutely forbidden to hit with a hammer and unreasonably. So as not to damage the divider inside the cam and needle bearings.
3, when processing fixtures, parts, accessories, and tools are installed, relative to the workbench eccentricity or step error should be adjusted and eliminated by the instrument.
4. The input and output shafts and their rigid shafts cannot be erected unreasonably. The cam divider should be fully centered.
The above is the brief introduction of Li An Printing Technology Xiaobian to everyone on how to carry out assembly of precision automation splitters. I hope today's Xiaobian's explanation can help everyone! Shenzhen Lee On Printing Automation Technology Co., Ltd., the main divider of R & D, design, manufacturing, the company to enhance the overall value of customers as their responsibility, provide the highest value for each customer service, manufacturing quality products, strive to develop into Asia's first cam Indexer supplier. If you want to know more about this, please visit the Lee's Indian website http:// Ali Store http:// to find out or dial 400-888-9385 to inquire!
Car Fuse Box,Fuse Box 12V,Fuse Box Fuse,Anl Fuse Holder
Dongguan Andu Electronic Co., Ltd. , https://www.autoido.com